Hi all,
I have a question: I used to control my condition levers with the two right-lower switch buttons on my CH Yoke. The setup was (I guess) in the old forum. If someone could direct me or tell me the right setup, I cannot find it anymore.
Many thanks!
Jamie
Comments
Found this on the internet
This is the buttons entry in the FSUIPC.ini file:
[Buttons.Dash8]
0=P1,30,Cx3200088E,x3E800FA0 -{offset sword increment, offset 088E (Incr=4000, Limit=16000)}-
1=P1,17,Cx4200088E,x00000FA0 -{offset sword decrement, offset 088E (Decr=4000, Limit=0)}-
2=P1,31,Cx32000926,x3E800FA0 -{offset sword increment, offset 0926 (Incr=4000, Limit=16000)}-
3=P1,18,Cx42000926,x00000FA0 -{offset sword decrement, offset 0926 (Decr=4000, Limit=0)}-
and the entry in themjc84.ini file:
CL1_FUELOFF =0
CL1_START =12000
CL1_850 =24000
CL1_900 =48000
CL1_1020 =64000
CL2_FUELOFF =0
CL2_START =12000
CL2_850 =24000
CL2_900 =48000
CL2_1020 =64000
Hi Jamie,
The original post can be seen at the link below, in case it's any help to other forum users.
https://web.archive.org/web/20171014002055/http://majesticsoftware.com:80/mjc8q400/support.html
Thanks,
Nick