helico55
About
- Username
- helico55
- Joined
- Visits
- 463
- Last Active
- Roles
- Member
Comments
-
Thank you so much 😀
-
hi. can you give me take off chart ? link doesn t work.
-
Ok i think my problem is probably surface control by yoke or rudder . I will try again. Thank you so much for your explanation.
-
TCS not activated, no input on the control surfaces or the minimum height not yet reached. What TCS ? What control surface ? What is minimum height ?
-
Ok super thank. I got this message while approach ,i was far away of my track because i had thunderstorm. Thank you for the link.
-
Ok for what that mean but what i must to do when i get this warning ?
-
Yes i have pro version. But i look in docs and i don't find any infos what i must to do when i get this caution light. First what that mean spoiler outboard ?
-
Because sometimes when I want to exit I have no control.no rudder work or tiller until I'm almost to stop before tiller begin to work.
-
When you exit from runway,do you exit by rudder or do you use tiller ?
-
why on the picture is supposed to have 3.00 descent and it descent at 5.03 ? I put 3.00 RNP in nav page. If you look i m too low when we look papi lights and my vnav magenta bar. 3 reds lights and 1 green light. it s runway 10 TNCM airport
-
-
Problem.i don't understand why not arm itself and many other post say supposed arm itself.
-
Why as well arm app in nav page not arm itself? Supposed arm itself from 30 nm of the airport. Each time I must to arm myself.
-
Why i's not same thing for npa and ils about begin landing conf ?