alainzu

About

Username
alainzu
Joined
Visits
30
Last Active
Roles
Member

Comments

  • Hello, this was of course my first hypothesis. I have verified that no buttons of my throttle quadrant and yoke were linked to any condition lever off command such as ctrl F1 or F2. I have deleted from fsuipc and P3d any axis assignment to condit…
    in CL moves to fuel cutoff during flight Comment by alainzu May 2020
  • Hello, I finally abandoned fsuipc calibration and programmed a P3dv4 calibration. I decided not to program any Prop axis. I still have the same random issue: Prop axis suddenly fall to fuel cutoff after take off or sometimes during cruise. I hav…
    in CL moves to fuel cutoff during flight Comment by alainzu May 2020
  • In this example, I selected a RNAV approach for LSZS and a new waypoint was added between ardax and ronag R21 CRS 221 which is the course of the final approach after ronag
    in RNAV GNSS Approach tutorial Comment by alainzu May 2020
  • Hello, a last question, what to do with the R(RW#) with the nav course which is added to my flightplan when I execute a RNAV approach? Best
    in RNAV GNSS Approach tutorial Comment by alainzu May 2020
  • Thank you very much for your comments. I think I have correctly understood and succeeded in flying a complete RNAV approach. The activation of the VNAV path is a little complicate in the dash FMS as compared to more recent aircrafts such as 737 or…
    in RNAV GNSS Approach tutorial Comment by alainzu April 2020
  • Hello, I followed the tutorial. It worked perfectly with a VNAV path, but when I activated APPR manually crossing BILDI, the airplane suddenly left the LNAV path to go direct to RW1???? What is wrong? Other question why to set RPN to 0.30? Best
    in RNAV GNSS Approach tutorial Comment by alainzu April 2020
  • Thank you very much for your RNAV tutorial, I will do it and come back if I have any questions. Best
    in RNAV GNSS Approach tutorial Comment by alainzu April 2020
  • Thank you very much, I am looking forward reading your tutorial soon
    in RNAV GNSS Approach tutorial Comment by alainzu April 2020
  • Thank you very much, I will try!
    in CL moves to fuel cutoff during flight Comment by alainzu April 2020
  • Thanks for your reply. I think I have difficulties programming my CH throttle Prop axis using FSUIPC. I tried to put Feather in the nul position but it does not work well. If you have some advice? Best
    in CL moves to fuel cutoff during flight Comment by alainzu April 2020
  • I can no more use the aircraft, CL always move to fuel cutoff without any action from me. When I load the aircraft, default failure initiated is displayed Is there any command to disable random failures ? For the moment, I just want to practice l…
    in Random Failures Comment by alainzu April 2020