NoelCP
About
- Username
- NoelCP
- Joined
- Visits
- 43
- Last Active
- Roles
- Member
Comments
-
@Postalmaintenanceman said: Count on my order for your Pro Edition for MSFS 2020 when it becomes available. Initially, post MSFS release, I spent about 50:50 time in P3D 4.5 and MSFS. Over the past 4 months now I've loaded exactly one fl…
-
Can't wait to see the Q400 in MSFS quite frankly. My initial reactions in MSFS after installing and learning the basics was to want to go back to the old soft shoe P3D w/ the lovely Dash 8. But curious to see more w/ the new sim and understand con…
-
All's well w/ the timer switch--thanks
-
Thanks, will do.
-
After I found an unused controller to setup as the tiller control for the NGXu I've been loving the level of fine control you have with it over any other plane in the hangar.
-
For some reason crew announcements are very low volume and muffled sounding. All of the P3D communications, ATC, GSX all sounds nice and clear so I'm wondering if there is a specific volume control for these announcements. I think it must be in the…
-
It's ok let's just agree to avoid each other. Sometimes that is the best policy. Best wishes and stay well.
-
Let me put it where the goats can get it: since I clearly CAN get to the full unobstructed front view, by first hitting Shift-1, then W twice, or as you mention F10, then W twice, this tells me this full view IS in fact available to me. What I'm h…
-
It's true, you folks are the least helpful 'customer service' I've experienced in the entire flight sim world over 35y now. You're legendary! But you choose to be this way and that is your right. I like the plane I just understand 'support' is k…
-
Something tells me no help will be forthcoming here. I will save a backup copy of panel.cfg and play with it until I figure it out myself. Bye Bye
-
Can you guide me on how to edit the panels so I can see the 3rd 'next panel' first? I'm only after getting a straight empty view out the front.
-
Hello?
-
Ok, thanks for the reply. I had wondered if something like that might be the case, however on the outside it seems somewhat pedestrian to have to validate a process before turning over control to, in this case, P3D/FSX. But again, thank you for le…