the Approach, so you always have to enter the 0.30 by hand. I had also bought the FO version of Airline2Sim because of another RNAV question, because the RNP 0.30 was named. But if I read that correc

for example, pmdg b737 calculates the correct height at this point: 3343ft

not yet APPR phase, at point WI103 the height is not calculated,so far so good

He asked me above: > and then probably the real Dash with a ANP 0.14 flies, can be yes (you can see on the NAV Page), but for the APPR phase are yes 0.3 vorgesenen.

I take it that your 53,000 lb is zero fuel mass (ZFM).

when landing heavy. Play with flaps at full (35) and 15 to see how you go. Initially I had better results with flaps at 15. Don't forget to watch the maximum flap & gear speeds.

I take it that your 53,000 lb is zero fuel mass (ZFM).

Hi, I have the Q400 1.02 installed on P3Dv4.5, Win 10 Pro (all updates installed).

So if this is the case the approach and landing speed cards are a mere guidance rather that the norms May I ask this forum what airspeed should I consider , say I have a 53 000 lbs payload on

everything works, but only with the XML Tools version from the : https://www.fsdeveloper.com/forum/attachments/xmltools64-zip.40019/

Proud supporter of http://www.ViaIntercity.com, 950+ flights for J41 & Q400 and 200+ for A320

Proud supporter of http://www.ViaIntercity.com, 950+ flights for J41 & Q400 and 200+ for A320

Flaps 35°. .................................................................................. 158 KIAS

I thought why there is no speed data for flap 35, for sure, if we go around, we immediately flaps up to 15!

Since we are in a simulator; Lets assume the airport is at or near sea level, the temperatures are above 20C, the aircraft landing weight is 57000 lbs, flaps 35 degrees, the chart shows VRef=116 kts.

it is the same as for a "normal" flaps 35 approach, as spoiler failures are not modeled.

I alternately pressed both, the left and right ALT key, and the only thing that happens is the Selection of the tab scenario in the upper left corner of the screen...

** I use FSUIPC in P3Dv4.xx to setup my trim controls. FSUIPC has the ability to change the trim speed in the sim via offsets. Using these offsets, I was able to closely match the trim speeds to the r

And where can I get Vclimb for landing speed (necessary if we go around) especially for flaps 35?

• A flap setting of 35° must be used.