SteveC
About
- Username
- SteveC
- Joined
- Visits
- 86
- Last Active
- Roles
- Member
Comments
-
Thank you for that explanation, I will continue with the browser
-
First of all sorry, I didn't know that it was possible to edit 2D Views. I now know how to do it and have got a view the similar to yours plus one other.( Very satisfying setting them up) Yes the No smoking and Seatbelt signs do work. I have …
-
I am disappointed with this software and cannot accept it is my settings that are at fault. I have tweaked a lot of settings and no change. I run on 4096 Res. The cabin view that I wanted, and was one of the reasons I purchased this software I can…
-
I am having different problems with this software, and it was suggested that I check if software is being pointed to the correct location. So I set location as full address for mjc400. I got same message as you! But If I leave location as just P3…
-
Please find image of Right click views available. I have my image settings on high ( 4096 ) Resolution. I can check individual settings if you advise best settings.
-
Yes chocks were showing. 13 Camera positions.
-
I could not conduct the test to see if the lights illuminate as I do not have those views. As I stated the with my first post the only new view I have is rearward looking passengers boarding view. No Cabin views at all. I do believe that updat…
-
I did as you suggested Uninstall and Reinstall but no change. The only cabin view I have is the rear looking 2d View. Have att. Screenshot of overhead after reinstall and screenshot of CFG File (http://majesticsoftware.com/forums/uploads/…
-
Yes it worked, and was easy to follow your instructions. Thanks for your reply Best wishes.Steve
-
Thank you Jax. I will try this out later today Steve