Ganlhi

Comments

• Thank you! I wasn't sure this does a proper reload.

  in Disable HUD Comment by Ganlhi October 2021
• Thank you both, I will make sure to try running CPAN in admin mode. Kroswynd, you say "reload the aircraft, not the simulator" but it should work anyway if I do this before starting the simulator, right? I was the case when I used the pro version …

  in Disable HUD Comment by Ganlhi October 2021
• Sorry for the noise, but I would really like some help on this 🙏

  in Joystick interface Comment by Ganlhi October 2021
• Sorry for the noise, but I would really like some help on this 🙏

  in Disable HUD Comment by Ganlhi October 2021
• Well, I tried changing the rate divider, and with a 0 value (like for the shared cockpit) it's a bit better but not reliable enough. And I still don't get any message for the GPWS Landing Flaps... I guess it's not ready for me to consider building …

  in Sometimes, outputs are not send on UDP Comment by Ganlhi January 2021
• I will definitely try that! Thanks

  in Sometimes, outputs are not send on UDP Comment by Ganlhi January 2021
• My bad... It works if I install the 1.020b patch! I didn't know this specific version was needed, then I found a post about it.

  in UDP interface question for PRO version Comment by Ganlhi December 2020
• Hello there! Does this work only with P3D v4 or v5? I have version 1.020a installed on P3D v2.5 and I cannot get UDP ports active for connector 3. I used netstat to check and I can see the the port for connector 2 (49240), I don't see the one for …

  in UDP interface question for PRO version Comment by Ganlhi December 2020