I'm desperate.I've been flying in the P3dV3 for several years without any problems.

Just purchased the training edition. Running P3D v5.

Solution: In the basic settings of P3D indicate "TAS" was checked instead of "KIAS". Now everything works fine again :-)!!!!!

I recently installed the Dash into P3Dv6 and have no click spots on the MCP for the autopilot.

O.k. so here you finally are. Approach is from my last flight 23/07/17

If this is not the issue, then are you able to provide a video of the issue. Since I very likely will not be able to replicate it since I no longer have older 32 bit versions of P3D installed on my t

* Happens no matter AP is on or off.

3) Could this be due to the weather? Tail wind? Stormy day?

since a few days I have the problem, that I can hardly reduce the speed of the Dash when approaching an airport. I did the approach according to the textbook as usual, but even with the landing gear d

I hadn't noticed it in my earlier flights in P3Dv6. I'm wondering if it was caused by the recent update. Has any one else noticed this? Is it a Q400 only, problem?

I recently installed the Dash into P3Dv6 and have no click spots on the MCP for the autopilot.

Hi there, just bought the plane today and downloaded latest version. I also have this unreadable issue with the MCDU. I use latest P3D version. Is this still under investigation from the dev?

Just now I tried the RNAV (RNP) Y RWY 35L into CYYC via SELEV, and the RF legs did the same thing. I do believe it has to do with where the FMS puts the "RNV Y 35L" waypoint in the FPL, as i

Just now I tried the RNAV (RNP) Y RWY 35L into CYYC via SELEV, and the RF legs did the same thing. I do believe it has to do with where the FMS puts the "RNV Y 35L" waypoint in the FPL, as i

Same problem remains in version 1.025a for fsx. Tried a route from LGLM to LGTS today with the same result. I have also the latest airac 2306 installed.

I have re-flown a flight from CYEG to CYYC and noticed the same behavior between MIDVI and ERDAL. On my first flight, mentioned earlier, I didn't notice the change in the way the Q400 was flying the a

Just now I tried the RNAV (RNP) Y RWY 35L into CYYC via SELEV, and the RF legs did the same thing. I do believe it has to do with where the FMS puts the "RNV Y 35L" waypoint in the FPL, as i

Here's me just now, trying to RNAV (RNP) Y RWY 30 into CYEG via OMENA. Interestingly, it actually programmed the RF Leg from SEDEN to LIDIR, but after LIDIR went direct to SEKOB, and didn't fly the RF

Actually, I took off from rwy 02, and was vectored onto the RNAV (RNP) Y RWY 30 via LETIX into CYEG. Then in Calgary I took off from rwy 35L and was vectored onto the RNAV (RNP) Y RWY 35L via SELEV in

I use the Training edition of the aircraft in P3D V5.4, with the most recent update, and I was flying the RNAV (RNP) Y RWY 30 into CYEG today, and noticed the plane couldn't/didn't program the RF legs