I am sorry - but the new patch for the training version for P3D v5 is not working for me at all. When I apply it, the Cold & Dark script is not executing anymore, the XML interface is not work

UPDATED 05/15/2023

I have the TRAINING edition on the Majestic Q400 for P3DV5.3, and I just did the most recent update for the x64 edition and I see the font in the HUD is different. Is this intentional? Or is this a bu

UPDATED 05/15/2023

It may be a Navigraph issue, but regarding RJOO TIGER2 Departure, there seems to be a problem with the route to TIGER when flying from Runway 32L/R.

Your problem may have multiple causes. #1. improper calibration, #2. dirty potentiometers in your controller, or #3 all of the above.

At the top it says that the package has been released for version 4 and 5 (admittedly this was 1½ years ago), but on SimMarket it is listed for P3D version 5.x or 6.x. Does it run with P3D V4.5 (whic

I launch The Control Panel, Pick my Flight Config press Apply and relaunch my P3D and my state is still the same as before as you can see in the pic. What Am I doing Wrong? I Have the Training edition

I tried to fly the approach as you have shown on your screenshots into YBMK. I used the WELKE1approach and followed then the RNP 32 approach according to the charts.

Now, one last thing. Do I put 1_025 on again? Onto my P3D V5.3 Pro?

> I tested Timmins (CYTS) and found the same issue of the FMS freezing. FS Commander shows an error in the navdata for the PETSU, and GUBUP transitions for the ILS 03. Choosing the BONAG, or YT

I tested Timmins (CYTS) and found the same issue of the FMS freezing. FS Commander shows an error in the navdata for the PETSU, and GUBUP transitions for the ILS 03. Choosing the BONAG, or YTS transit

> I was flying Toronto to Timmins, once I started entering the approach, after selecting it, the map and FMS and part of the PFD stopped moving... It was selected for the ILS 03 YTS. Where can

I was flying Toronto to Timmins, once I started entering the approach, after selecting it, the map and FMS and part of the PFD stopped moving... It was selected for the ILS 03 YTS. Where can I downloa

> @kroswynd : I tested the same route with the Aerosoft A320 Professional with the same Navigraph AIRAC. I could enter the route without problems. When I entered it, the FMC showed a discontinu

All simulated aircraft are not developed alike, so making a comparison with other aircraft in the simulation arena does not hold much water. No one has eluded to your system being the issue, but it c

@kroswynd : I tested the same route with the Aerosoft A320 Professional with the same Navigraph AIRAC. I could enter the route without problems. When I entered it, the FMC showed a discontinuity (=&qu

the issue and possibly test another aircraft in P3D v5. 3 to see if a similar response is triggered.

I have the training edition 1.025 in P3D v5.3. I use Navigraph and I have installed the AIRAC 2304 rev 1.

* There has been a recent NavLoad Airac from Navigraph (4/20/23), I would suggest using the most recent one to see if the issue is still there (assuming that you are using Navigraph).