Douglas999
About
- Username
- Douglas999
- Joined
- Visits
- 810
- Last Active
- Roles
- Member
Comments
-
Thanks for the reply. Can you get outputs with LINDA and if so which type of board are you using? I have the overhead inputs working with UDP and Ardunio but not the outputs. I can share an example of UDP inputs if it helps. I haven't figured ou…
-
Hi Reinhard Thanks for the reply, this was indeed the problem, I remembered you said that and tried it last night. I now have the data on the network and have managed to set it uo to display on the serial monitor on the ardunio, I just need to figu…
-
Hi again looking at outputs and again following Reinhards logic of testing the basics first, I have configured the fire wall with a rule for port 49250 outbound and tested between the sim computer and another with a basic UDP send and receiver, a…
-
Ok I have done some more testing and despite my lack of coding experience or any real knowledge, I have managed to get it to work. To send the datagram via an ardunio I used a HEX array which I declared first and then coded to send on the switch clo…
-
Ok I have done some more testing and despite my lack of coding experience or any real knowledge, I have managed to get it to work. To send the datagram via an ardunio I used a HEX array which I declared first and then coded to send on the switch clo…
-
Thanks for the reply, i will do some more searching on the ardunio forum. its a shame that programs like simvim and mobiflight dont mention the Q400 even though they work with Xplane via UDP
-
Hi I have finally bought the Q400 Pro edition for P3d V5 while waiting on the Training / Cockpit edition ( no I am not asking when ) The aircraft looks fantastic and I am looking forward to learning to fly it. I have been reading the forum for…
-
Thanks, I will keep working at it
-
Hi Reinhard I have started looking at how to interface the via UDP following your logic open ports, check with netstat etc. I see the ini file contains an entry for UDP conector 3 (3RD party) that is enabled, can you tell me what else nee…
-
The Joystick calibration tab of FSUIPC has the check box to reverse controls. This is the paragraph from the manual * The other option is Rev. If you check that, FSUIPC4 reverses the axis completely, just before supplying the calibrated valu…
-
I think there is a reverse setting in FSUIPC that you could try.
-
I have looked at my drawings and can give you the following dimensions DC control panel 146mm wide by 90mm high Exterior lights 146mm wide by 40mm high PFD Altimeter units 146mm wide by 40mm high ELT Flight Data RCDR 1…
-
Hi Haeriphos I am also researching the dash 8 with a view to building a full hardware cockpit. I obtained a copy of a training poster from https://shop.aviatastraining.com/ at a very reasonable price. ( digital download) I have printed secti…