The default ini assignments for the autopilot and TCS can sometimes cause binding issues depending on the controller on has. But you have found the issue. Bear in mind if you perform a reinstallation

Please disregard i have sorted the problem. Took out the TCS line in the .ini file and that sorted it out.

I have deleted all key assignments in P3D4 sim for the Bravo throttle and Saitek yoke and assigned a number of commands through FSUIPC including view changes and trim changes. On the Saitek yoke i ha

You have pointed me in the right direction by noticing the TCS displayed in the PFD.

The Flight/Taxi Switch must be in the Flight position, by the way, but has nothing to do with it. But you activated TCS (Tactical Control Steering) on ​​the yoke, coincidence? This disconnects the ser

TCS = b10

Similarly, if you wanted to program the TCS Button this way it would look like this:

J0_b2=AFCS_->inputs.TCS_button

Got the Pro update installed and all is well now. Even got TCS and GA programmed

in mjc84.ini i set J0_b2=AFCS_->inputs.TCS_button

simply want to assign a specific button to the TCS?

J0_b2=AFCS_->inputs.TCS_button

J1_b5=AFCS_->inputs.TCS_button

I'm using aileron, elevator and rudder via mjc84.ini, as well, TCS and AP Dis. buttons; Tiller was configured to Axis Spoilers in Control Panel and assigned inside P3D4.5 Control page.

J0_b2=AFCS_->inputs.TCS_button

More than likely it is bound in the mjc84.ini (simply remove that line to disable the TCS especially if it is not a feature that you use), and you have that button also assigned via whatever button bi

I don’t press the TCS button, I don’t know which key controls it ... I just press the trimmer up or down on the joystick and see the indication TCS.

TCS will be indicated on the PFD if the bottom assigned to the function is held. Sounds like there is possible a doubke binding event in place, you should double check to ensure this is not the case?

when the autopilot is on and we use the trim buttons on the steering wheel, we see the indication (TCS), so it should be??

Just a little comment to avoid confusion: I don't use spad.next. I'm just trying to assign the Autopilot mode functions directly to the Joystick buttons, just like the ones I already have for the TCS