Hi Folks. I recently upgraded Q400 pilot to pro version on P3D v4.5. Then upgraded to 1.20b.Loving this bird as always. I tried to enable 125Hz controls as per the instructions on the forums but it di

Have you read our thread on P3D v5 and the Q400? You are attempting a function which was spoken about.

I have deleted from fsuipc and P3d any axis assignment to condition levers.

May I just chime in to clarify that it mustn't be an actual axis but something like "Set Condition Lever Off" could also be a plain keybinding somewhere you should look for. I know FSX has t

One idea, which came across my mind (but I am not sure, if it is possible to use these features in the free version), is to use the 288 virtual buttons provided by FSUIPC via offset 0x3340. You could

Thanks, I used CSPAN (out of v5) to configure. But before that I tried with copying the ini file. Well I think I will test a bit more using FSUIPC (controllers are deactivated in both versions of P3D)

I finally abandoned fsuipc calibration and programmed a P3dv4 calibration.

The tiller functionality if not working is more than likely driven by an improper setup. The tiller once properly configured will work as it did in version 4 of Prepar3d. Very likely if you are tryin

Hello I have read all forums and cannot find a solution... On touchdown there is a very big camera shake but my landing rates are top ( -22 ...) I have removed all shake from EZDOK 3 with no success .

> Is the Q400 Pro Prepar3D v4.5 Hotfix 3 compatible?

Is the Q400 Pro Prepar3D v4.5 Hotfix 3 compatible?

For me the tiller is not working in P3D v5.

I've done exactly the same thing, used it for about 2-3 hours now and appears to be working pretty well. Happy with that, as it's a great package and I've never had any running issues with it. Cheers

As mentioned we are not providing any support for P3D v5. Feel free to post any issues seen that have not already been mentioned. Installation via XML is also something that we won't support at this

and from here

Mr. Good evening, I installed it the Majestic q400 to P3DV5, it works perfectly, I did it through xml documents\Prepar3D Addons v5 All works great.I would to provide help to majestic i know that is no

Getting back into sim flying. Installed a fresh P3D V5. If I purchase the q400 can it be installed?

alert at startup: this gauge version must be used under Prepar3D v4.0 or higher

When I do this, the aiplane flies itself off the ground some 10 kts after vrot. I suppose it must have to do something with the loading. I use P3D V4, Pro64 ed.

Hi, this is an issue I've been having as well, I upgraded from FSX to the 64bit PRO from simmarket. The initial install created a FSX folder even though I am running the 64 bit version. I copied the f