Here are the screenshots from my setup:

How goes it? The behavior being exhibited has been a long time nuisance within the FSX and P3D platform where by the aircraft would initiate a momentary turn in the opposite direction before proceedi

3 - After few seconds the acft veers right as it should be.

3. The tiller is no longer effective after 40 knots as there is enough wind flowing over the rudder. So your rudder authority should be effective, unless you are using the auto rudder switch which

Will you be able to make the new installers use the new P3D Addon method. I was able to move files manually after installing into the sim first - and then used Lorby's tool to create the xml with eff

it is for him that i stay on P3D

yes i am. CTL+F2 decrease and F3 increase. Not sure why i can no longer drag using the mouse which i previously could.

Not an issue I recall seeing over the few years that the Q400 has been in existence. I asked in my previous post if you are able to move the condition levers (CTRL + F2 or F3)?

I use P3D V4 Win 10.

The only - ONLY - way you see this is if you have content errors active in P3Dv4.5.

That's the error from P3D V4.5

before turning over control to, in this case, P3D/FSX. But again, thank you for letting me know it's going to stay that way for now. Cheers

I look forward to seeing what is coming, for P3D V5, for FS2020 (or whatever it will be termed), and for new aircraft. I loved the Q400 from the first day and it is an addon I return to again and aga

APU BLEED is instantaneous on the Majestic when the switch is pressed, it takes at least 20 to 30 seconds until the full flow is available on the real one...

A bit stumped by this one. May I ask you to un-install again and re-install using Administrator Rights as you have previously done. Be sure to load one of the default aircraft within the P3D v4.5 pla

As mentioned in the title will the Dash 8 compatible with the new P3D?

Yes, I installed into my P3D folder which was the suggested. I have the latest nvidia drivers version 445.75. I have also tried clearing my shader cache, which was suggested in an old thread, howeve

I'm running Prepar3d version 4.5 and I just reinstalled the Q400 from a freshly downloaded installer from Simmarket (file name "mjc8-400-Pro-1_020x64-inst.exe") and ran as administrator. Wh

After years of joy using the Q400 Pro in P3Dv4 I have now encountered a problem that may be attributed to the latest windows 10 update (I hope). After a flawless 90min leg in the Q400. I exited P3D an

Trim is perfectly fine for take-off or in any other phase of manual flight. However, as soon as the Autopilot is engaged - by the respective button in the VC - the elevator gets trimmed fully nose dow