CMBAviator
About
- Username
- CMBAviator
- Joined
- Visits
- 81
- Last Active
- Roles
- Member
Comments
-
I've set it like the frist screen, pretty much centralised and the rim in the upper white band limit, and it still very hard to keep below 15 deg of pitch attitude Power set is at 90% torque
-
Hey, I have a brunner yoke that creates a virtual joystick and it doesn't work with the software. Even if the software reconized my virtual joystick, when moving the axes, the figure are not mmoving
-
@ferrariman15 said: Landing in the correct spot is far more important than getting a "greaser". The FS community places far too much emphasis on so called "greasers" but if you are using half the length of the runway to achieved it then it is not…
-
@afcraig2010 said: Just to give another airline perspective, my airline flies at 10 degrees pitch below acceleration height. At acceleration height we hold the 10 degrees pitch until the pilot monitoring calls flaps zero, then we accelerate to 24…
-
@afcraig2010 said: Trim is set only with the electric trim switches and in real life I just put it in the center. In the sim I leave it where it defaults which is forward of center but still in the white band. Okay thanks. But is it norma…
-
@afcraig2010 said: I don't normally use the FMS tune but I think that's all it will do-- tune the radio. You still have to set the inbound course, switch from FMS1 to ILS1 (magenta to blue needles). That's the minimum setup to get the ILS info di…
-
thanks for your inputs guys
-
@kroswynd said: Well, believe it or not, I had the pleasant or unpleasant (depending on how you look at it) experience of this a few evenings ago. Still not able to pin point the cause, apart from the fact that it was the first long haul flight …
-
It would be a shame if a force feedback doesnt work correctly with the majestic, as it supposed to be used for pilot trainning. I've sent them an email, i have to wait
-
@ckyliu said: Training edition is not yet released but I believe it will be available to the general public should you need to make use of the additional functionality or cockpit build. I see no reason why the yoke wouldn't send input. I'm…