3 Vendor from which purchase was made

and experience or not a CTD with p3d.

but push the Copy PLT RTE RSK3, p3d immediately suffers a CTD.

Hello folks,

3 Do you have the "WEAR_OFF_FACTOR" activated in the mjc84.ini? This could trigger an event which may not be resettable.

You very helpful, Thanks. I did confirm that texture.BBO folder exists, and I was able to load the livery. my True Glass works. I have front wheel chocks only. There are no main gear chocks. I di

3 Do you have the "WEAR_OFF_FACTOR" activated in the mjc84.ini? This could trigger an event which may not be resettable.

Output folder: F:\Lockheed Martin\Prepar3D v5\SimObjects\Airplanes\mjc8q400\cpan

I suggest you assign as much as you can through either the ini file or the utility (not sure which version has the latter) and avoid default p3d/fsx stuff

Our focus moving forward will be on MSFS 2020, and we will determine future plans for P3D v.5x

OK, upon further investigation, the trim jumps to nearly full nose down when I press AP DISC on the yoke. I have no FSUIPC or P3D native binds for that button. Here are some before and after shots of

I am using the ini file binds, but I will double-check that there is not also conflicting P3D native/FSUIPC binds.

Most likely P3D's Autopilot kicks in if you were using Z to disengage via the button assignment of your joystick.

Hi, I've got the Q400 for P3D with the visual extension. The chronometer digital displays are very dim, almost unreadable unless you zoom in close. Is there any way to adjust their brightness?

Here is a link to that thread: http://majesticsoftware.com/forums/discussion/1319/autopilot-disconnect-sound-in-1-024

The Q300 for FS2004 AND FSX will not work on the P3D platform.

The Dash8-300 training edition, will it work in p3d v4.5?

The training edition for the Q400 is not for MSFS 2020, it is ONLY for Prepar3D v4.5 and v5.3

Is this training edition only for MSFS, will it work in p3d v4.5?

I installed the new mjc8-400-Pro-1_024_x64-inst.exe and Visual Extension mjc8-400-VisExt21-1.024-inst.exe. All good, but when I checked the standby ISI, it said MJC84-1023B, rather than 1024. Anythin