I recently had to reinstall the Q400 in P3DV4.5. Now as I take off the ailerons and elevators are not working with the joystick at all. The Q400 turns left off the runway and if I manage to get airbor

Save the repaint from photoshop (or whatever you're using) as BMP 32bit, open it with microsoft paint, then save it as BMP with paint.

Good news Kroswynd, the problem is solved! Someone suggested to cancel the Prepar3D.cfg and all reflexions dissapeared. And I am happy again!

i am using p3dv5, thrustmaster throttle quadrant and thrustmaster side stick, i try to engage the AP with assinged key, by clicking the ap button manually, but no change

Hey, after updating P3D to v5 I have on the glass of the Dash-Instruments sun-reflexions, even in fog. To demonstrate the effect I made a picture PNG but I dont know how to insert here. Sorry!

majesticsoftware.com/forums/discussion/comment/3846#Comment_3846

I'm using P3Dv4 HF3 and the Q400 Pilot Edition v1.021.

So it may seem that you more than likely have improperly configured your input device assignments, which is a common error experienced by many. Unfortunately we are not able to determine your input d

Hello,

and then reload the aircraft. If you are using P3D v5 you will have to select another livery rather than the same one as LM seems to have changed up some of the logic that existed in v4. BUT config

and then reload the aircraft. If you are using P3D v5 you will have to select another livery rather than the same one as LM seems to have changed up some of the logic that existed in v4. BUT config

Hi cmbaviator2, You have a controller conflict. Your throttle controller may have been auto assigned to the aileron, elevator, and rudder by P3D. Check your engine control axis' assignments in the P3

I haven't flown this bad boy for about 1 years and I'm now on P3DV5.1. I've just installed le .1021 version, set the axis in FSUIPC and in the 125Hz control panel. Although the axis values moves in th

Why turn off? This would be required at most if it is in the abnormal checklist in the event of malfunctions (I would have to check)

Q400 Pro P3D V5 pro

The reference point for calculating the 50 NM or 30 NM distance is the last point of the approach (EoA). Could it be that you have an interruption in the form of a holding in the routing, where I beli

sorry for delayed response. No, I deleted P3D upon new system and installation of MSFS. Now awaiting the Q400 + for this system, whenever it arrives.

Hello Günter, that had nothing to do with changing the version of your P3D, because that was always the case.

If everything else for that system is functioning normally then we suspect that the TCAS button is also working and I suspect that you may be confusing the functionality of certain buttons/systems.

You issue does seem a bit off, however if I may ask?